|
For use on paving, flags, slabs, cobbles and stone setts. It is ready mixed and can be brushed into joints with minimal effort and then easily finished by compacting pointing tool. There are therefore huge time saving benefits compared to applying traditional mortar.
Because Geo-Fix is cement free and applied dry it does not leave the unsightly and difficult to remove cement stains associated with traditional mortar.
Unlike mortar joints Geo-Fix is totally resistant to freeze-thaw cycles and will not crack or pop out with frost.
Geo-Fix forms a solid joint that resists weed and plant growth yet is water permeable, allowing water to escape to prevent ponding.
Choose between a buff or a grey colour.
Step 1 |
Step 2 |
Step 3 |
Step 4 |
Step 5 |
|
|
|
|
|
| Lay paving allowing minimum 5-6mm joint width and 25mm depth |
Open vacuum-packed bag and sprinkle over area to be joined. Work in small areas 2-3 sq mtrs. Entire bag must be used within an hour of opening |
Using a soft brush, push the compound into the joints at a 45mm angle. |
Firmly compact with a pointing tool, refill and repeat to ensure a fully compacted and topped joint. This is key to successful laying and ensure the Geo-fix is finishedslightly below the surface |
After application, brush off excess with a soft brush, taking care not to brush out any Geo-Fix from the treated area. Geo-Fix will harden over a 2-3 hour period |
Use Geo-Fix® Jointing Compound within 45 minutes of opening.
Protect treated joints from rain until fully cured. Any contact with rain and water before the compound has set will affect the product.
Do not use at temperatures below 0° C or in wet weather.
The jointing should not be cleaned by use of high-pressure washers until cured for 7 days. The distance between nozzles to jointing must be at least 10 cm. |
